Specifications - Signature Line
Steel Frame, Belt Conveyors
  1. Drive Package: The Direct Drive package includes a C-faced, TEFC 1/3 hp motor. Motors through 1 Hp are 110/60/1 voltage and come with a thermal protected toggle switch motor starter in a NEMA 1 enclosure. 15' of SJ cord with a standard three-prong plug is pre-wired to the starter (other voltage and motor starters available). Control wiring is contained in liquid tight conduit and connectors. Drive packages for conveyors 3'-30' long have 150lbs. maximum load (drive packages for heavier loads are available).
    NOTE: If an optional variable speed drive is purchased, we do not recommend running the motor at less than 1/3 of the overall output (speed), as this could result in lowering the life expectancy of the motor. If you are planning on running at less than 1/3 of the output, please consult an EMI Representative.
  2. Belt guidance: True Track Belt Guidance System comes standard on 3'-30' long conveyors. Using a Double V-guide slot in the frame, 1/4" wall crowned pulleys, and bonded Double V-guide belting, “True Track” minimizes belt run off and reduces belt tracking maintenance.
  3. Pulleys: To ensure long lived operation, 31/2" diameter crowned pulleys incorporate 1" diameter shafts, self aligning sealed ball bearings with eccentric locking collars, telescopic take-up adjustment, position locking nuts, and Zerk grease fittings.
  1. Belting: Our easy to clean, FDA approved, white, PVC belting with staple-type belt lacing (which prevents lacing pullout and splice failure), makes belt maintenance quick and easy. Inclined conveyors have a bottom cleat support plate and bonded flexible cleats that have no bolts or rivets that may tear out.
  2. Frame: Our sturdy, reinforced, welded, cross-braced steel frames, painted OSHA orange (other colors are available) incorporate 12-gauge channels with a 16-gauge slide bed to minimize twist and camber, and provide longer service life.
  3. Rails: To ensure molded pieces do not get pinched, damaged, or lost between the rail and belt, we place our 12-gauge 4" rails so that they overlap the belt by 1/2". To keep your molded parts contained on the infeed end of the conveyor, we include an infeed-end backpiece.
  4. Shipment: Generally conveyors 3'-10' are shipped fully assembled, pre-wired, tested, and ready to run (legs must be attached). Conveyors 11' and over are shipped partially assembled to minimize shipping damage. Some frame and belt assembly is required; drive packages and system panels are pre-assembled and tested. For your convenience, arrangements can be made for longer conveyors to be shipped assembled.
  5. Leg Sets: Quick adjusting leg sets and locking swivel castors are optional (not included) on RM and RMC conveyors. Consult factory for different style and size leg sets.