Specifications - Signature Line
Kurv-King (KK) - fixed and adjustable angle, Conveyors
  1. Drive Package: The Direct Drive package includes a C-faced, TEFC 1/3 hp motor. Motors through 1 Hp are 110/60/1 voltage and come with a thermal protected toggle switch motor starter in a NEMA 1 enclosure. 15' of SJ cord with a standard three-prong plug is pre-wired to the starter (other voltage and motor starters available). Control wiring is contained in liquid tight conduit and connectors. Drive packages are sized for a 50 lb. maximum load. NOTE: If an optional variable speed drive is purchased, we do not recommend running the motor at less than 1/3 of the overall output (speed), as this could result in lowering the life expectancy of the motor. If you are planning on running at less than 1/3 of the output, please consult an EMI Representative.
  2. Belt guidance: True Track Belt Guidance System comes standard on KK/KKI conveyors. Using a Double V-guide slot in the frame, 1/4" wall crowned pulleys, and bonded Double V-guide belting, “True Track” minimizes belt run off and reduces belt tracking maintenance.
  3. Pulleys: To ensure long lived operation, 31/2" diameter crowned pulleys incorporate 1" diameter shafts, self aligning sealed ball bearings with eccentric locking collars, telescopic take-up adjustment, position locking nuts, and Zerk grease fittings.
  4. Belting: Our easy to clean, FDA approved, white, PVC belting with staple-type belt lacing (which prevents lacing pullout and splice failure), makes belt maintenance quick and easy. Inclined conveyors have a bottom cleat support plate and bonded flexible cleats that have no bolts or rivets that may tear out.
  5. Frame: Our sturdy, reinforced welded, cross-braced steel frames, painted OSHA orange (other colors available) incorporate 12 gauge channels with a 16 gauge slide bed to minimize twist and camber and provides longer life service.
  1. Rails: To ensure molded pieces do not get pinched, damaged, or lost between the rail and belt, we place 12-gauge, 4" rails so that they overlap the belt by 1/2". To keep your molded parts contained on the infeed end of the conveyor, we include an infeed-end backpiece.
  2. Shipment: Generally conveyors are shipped fully assembled, pre-wired, tested, and ready to run.
  3. Leg Sets: Quick adjusting leg sets and locking swivel castors are included as standard on all Signature Line Kurv-King conveyors. Standard leg sets are adjustable up to 34" infeed belt height on standard conveyors. Belt height must be specified. For leg sets over a 34", consult factory.
  4. Transition Point: Telescopic tubing allows for gross angle adjustment and an adjustment screw for fine tuning. Our overlapping-rail design has allowed us to place a wheel on top of the belt at the transition point, of flat to incline, ensuring the belt stays snug with the frame. On conveyors 24" and 30" wide, we have moved the drive package in front of the infeed section to “push” the belt, reducing strain at the transition point.